Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000020-002.book Page 14 Tuesday, December 18, 2012 10:49 AM
en
14
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 6).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power
tool.
Switching on:
Push the switch toward the front (I).
Switching off:
Press the switch downward ().
Adjusting the sanding-belt speed (Fig. 7 – 8).
The sanding-belt speed can be variably
adjusted in the range indicated in the follow-
ing figure.
Set the dial control between "1" for the low-
est sanding-belt speed and "6" for the highest
sanding-belt speed.
Publicidad
