Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000020-002.book Page 15 Tuesday, December 18, 2012 10:49 AM
Operating Instructions.
The self-start lock prevents the power tool
from automatically restarting again, even after
a brief interruption of the power supply, e. g.,
from a pulled mains plug.
Guide the machine with the sanding belt
against the pipe subject to sanding until the
pipe is covered about halfway by the sanding
belt.
Sand the pipe uniformly applying a continu-
ous length motion.
Always hold the machine with both hands and
at a right angle to the pipe (also applies for
pipe arcs).
Repair and customer service.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Sanding belt
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the power
tool from the power supply in order to avoid
accidents.
When using in environments
WARNING
with conductive dust in the air,
such as when working metals, this dust can
settle in the interior of the power tool. This
can impair the total insulation of the power
tool. Therefore, regularly blow out the interior
of the power tool from outside via the ventila-
en
15
Publicidad
