EN
10
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
11
TROUBLESHOOTING
Problem
The motor does
not start when
you pull the trig-
ger.
The machine
smokes during
operation.
The motor is on,
blades do not
move.
There is too
much noise
and/or vibration
during operation.
NOTE
Possible cause
Solution
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack
Charge the bat-
is out of power.
tery pack.
1. Immediately
stop the ma-
chine.
The machine
2. Remove the
has damage.
battery pack.
3. Speak to
service cen-
ter.
Do not use the
The machine
machine and
has damage.
speak to service
center.
Remove battery
The blades are
pack then clear
blocked.
blockage from
the blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loosen.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have
machine and
damage.
speak to service
center.
English
12
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Charger model
13
LIMITED WARRANTY
YEAR/ANS/AÑOS
TOOL WARRANTY
GARANTIE DE
L'OUTIL
HERRAMIENTA
®
Greenworks
hereby warranties this product, to the
original purchaser with proof of purchase, for a period of
three (3) years against defects in materials, parts or
workmanship. Greenworks
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use that have not been hired or
rented for industrial/commercial use, and that have
been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to
misuse, commercial use, abuse, neglect, accident,
improper maintenance, or alteration; or
2. The unit, if it has not been operated and/or
maintained in accordance with the owner's manual;
or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants,
blade sharpening;
5. Normal deterioration of the exterior finish due to use
or exposure.
HELPLINE:
Warranty service is available by calling our toll-free
helpline, at 1-888-909-6757.
8
40V
3000(±10%) SPM
610 mm
3/4''
5.7 lbs.
BAF722 and other BAF
series
CAF series or 29482
charger
®
, at its own discretion will