DBI SALA 3900105 Manual De Servicio página 6

Ocultar thumbs Ver también para 3900105:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
3.2.12: After the lock nut is removed, pull all the
lifeline through the bottom of the housing and
entirely out of the SRL.
3.3
INSTALL NEW LIFELINE:
3.3.1: Push cable stud end of new lifeline assembly
through bottom of SRL bushing and out top hole.
Some alignment of the lifeline may be required to
allow the lifeline to push through the SRL.
3.3.2: Install lock nut onto cable stud with 9/16 inch
and 3/8 inch wrenches. Tighten lock nut.
3.3.3: Pull back on the lifeline to allow the lock nut
on the lifeline end to fully seat into the internal cable
drum.
IMPORTANT:
Look into the hole at top of the SRL, or
look into the side hole, to confi rm that the nut is fully
seated.
3.3.4: Return to the back cover.
WITH 1/8 INCH ALLEN WRENCH, TURN
THE SET SCREW ALL THE WAY OUT
(COUNTERCLOCKWISE) UNTIL IT STOPS.
INITIALLY, THE SET SCREW WILL TURN WITH
LITTLE RESISTANCE. STOP TURNING THE
SET SCREW WHEN RESISTANCE BECOMES
NOTICEABLY GREATER. OVERTIGHTENING THE
SET SCREW WILL DAMAGE THE THREADS IN
THE HOUSING. THE SET SCREW SHOULD BE
HAND TIGHTENED TO APPROXIMATELY 60 IN-
LBS (6.8 NM).
6

Publicidad

Tabla de contenido
loading

Tabla de contenido