Roadside Panel; Installing The Monitor; Installing The Transformer - CFI EXTEL IRON Instrucciones De Uso

b. Roadside panel
1. C-MOS camera lens with automatic focus, equipped with a lighting for a low-light vision (for night vision, use an
additional lighting system).
2. Speaker: allows to be heard outside.
3. Name holder and call button: when pressing this button, the internal and external unit ring, the camera and the
monitor start working (illuminated name holder). (If muting only rings outside)
4. Fixing screw of the front face on its frame. Remove this face to have access to the connection terminal block
and to the mounting holes of the roadside panel
5. The microphone allows you to communicate with the internal unit.
6. To write the name on the label holder, carefully release the front part of the name holder with small screwdrivers.
4 INSTALLING
Note : If you try your video door phone before installing it, do not do it with the roadside panel and the monitor
in the same room, otherwise the video door phone will produce a shrill sound (Larsen effect).
a. Installing the roadside panel
1. Separate the front face from the camera block by removing the 2 screws (a).
2. Through the cable gland (b), pass the 2-wire cable coming from the monitor and the one of the strike and/or
the one for controlling the automatic gate opener.
3. Fix the roadside panel on the column with 2 screws in the holes (c).
4. Connect the wires to the terminal block (d).
5. The "ball" camera (e) can be rotated without tool.
6. 2 settings accessible on the upper part of the roadside panel:
To change the settings, use a small screwdriver and turn it carefully without force to the abutments.
(f) on the left, setting of the sound level for the speaker of the roadside panel.
(g) on the right, setting of the sound level for the speaker of the monitor.
7. Micro-switches (h) to configure the intercom panel according to the installation.
8. Replace the front plate and secure it by replacing the 2 screws at the bottom of the roadside panel (a).
Make sure to position the front panel in the notches located at the top of the roadside panel.
Important: Do not put screws into the microphone hole (5, fig.3).
Important: Insert a silicon seal on the upper half between the intercom panel and the wall (i, fig.4)
Do not install a silicon seal on the lower part to avoid any condensation resulting in premature oxidation of the
electronics.
Important: Do not point the video camera directly at the sun or at reflecting surfaces.
Tip: we recommend passing the cables through a protective sleeve to shield them from impacts and the
weather.
b. Installing the monitor (fig. 5)
1. Fix the wall-mounted support
2. Connect the 2 wires coming from the roadside panel to the 2 power supply wires carefully observing the
wiring diagram
3. Install the monitor on its wall support .
4 . Only after having connected the roadside panel, connect the 230 V~ power supply to the adapter (4) (on an
installation compliant with standards in force, NFC 15-100 for France).
Make sure the power supply polarity is correct.
c. Installing the transformer
- Attach the transformer to a DIN rail in a modular fusebox or to a flat surface using the two black lugs clipped to
the sides of the power supply.
3GB
(fig. 3)
(fig. 4)
CFI EXTEL IRON - 05/2011 - V1