Location; Ice Maker - Hoshizaki IM-240ANE Manual De Instalación

1) After removing the packaging, make sure that the
icemaker and the storage bin are in good condition. If
in doubt, please do not use the icemaker but apply to
professionally qualified personnel. See the instruction
sheet attached to the storage bin for its unpacking and
installation guidelines.
2) Remove the icemaker panels to gain access to the
accessory kit and to assist easier installation.
3) Remove the package of accessories. Check the contents
according to "2. ACCESSORIES".
4) Remove the shipping tape holding the bin control switch.
5) Remove the protective plastic film from the exterior. If the icemaker is exposed to
the sun or to heat, remove the film after the icemaker cools.

4. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 1°C to 40°C. Normal operating water temperature should be within
5°C to 35°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect
production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Side View
(Air-cooled model)
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
IMPORTANT
Top
30cm
Rear
Front
30cm
ICEMAKER
b
c
a
WARNING
CAUTION
NOTICE
Side View
(Water-cooled model)
Front
3
ENGLISH
a) Front Cover: Remove the screw(s).
Lift up and pull toward
you.
c
b) Top Panel: Remove the screw(s).
Simply lift off.
c) Side Panel: Remove the screw(s).
Slide forward slightly,
and then lift off.
d) Rear Panel: Does not require
removal.
Bin Control Switch
Top
15cm
Rear
15cm
ICEMAKER