Working With The Machine - Festool KP 65/2 Manual De Instrucciones

GB KP 65/ 2

Insert the stop pin [1-4] into the rear
recess on the edge trimmer [2 A].

Insert the rotary knob [1-2] into the
opening above the stop pin [1-4] [2 B].

Tighten the rotary knob [1-2] by turn-
ing clockwise [2 C].
Disassembly
Removal in reverse order.
6.2 Fitting the stop pin for round
workpieces [3]

Insert the stop pin [1-4] into the re-
cess under the fine adjuster for the
trimming length [1-3] [3 A].

Insert the rotary knob [1-2] into the
opening above the stop pin [1-4] [3 B].

Tighten the rotary knob [1-2] by turn-
ing clockwise [3 C].

Slacken the rotary knob [1-2] by
turning anticlockwise half a revolu-
tion so that the fine adjuster for the
edge length [1-3] moves freely [3 D].
Disassembly
Removal in reverse order.
Series production: When ma-
chining several round workpiec-
es with the same radius, the
trimming fixture with blade [1-5] can be
set to the same position for all edge
bands.

Edge band trimming process (see
chapter 7.2).

Tighten the rotary knob [1-2] before
trimming the edge band.
The trimming fixture with blade
now set and secured in the same position
for all edge bands.
10
7

Working with the machine

7.1 Trimming edge bands on rectan-
gular workpieces

Fit stop pin [1-4] for square work-
pieces (see chapter 6.1).

Slide the protruding edge band into
the trimming fixture with blade [1-5]
[4].

Push the edge trimmer up to the stop
pin [1-4] parallel with the workpiece
[4].

Push the handles [1-6] together and
trim the edge band [5].
7.2 Trimming edge bands on round
workpieces

Fit stop pin [1-4] for round workpiec-
es (see chapter 6.2).

Glue the edge band to the workpiece.

Move the machine with the edge
band away from the workpiece ap-
prox. 10 cm in front of the cutting
point.

Apply glue up to the cutting point
and leave some space between the
edge band and workpiece so that the
edge band is not glued to the work-
piece [6 A].

Mark the cutting point on the edge
band [6 B].

Allow the protruding edge band to
[1-5] is
move over the stop pin [1-4] and
slide into the trimming fixture with
blade [1-5] [7].
Caution, sharp blade! Risk of
injury! Keep fingers well away
from the blade on the trim-
ming fixture [1-5].