Skytec 178.033 Manual De Instrucciones página 5

G. USB CONNECTION
For connection of a USB stick with MP3 files
H. SD CARD CONNECTION
For connection of a SD CARD with MP3 files
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly
for the suspected problem speaker. If the "normally correct speaker" is experiencing the same difficulties or
problems as the suspected problem speaker, use the information below to isolate the problem.
Possible cause No
output
Cables
Intermittent
Poor connections
Constant noise, buzzing and/or humming
Faulty electronic Any constant noise originates in the amplifier, mixer, signal processing, source device in the
signal devices, or line-level wiring. Check and correct system grounding as required. chain
sources or electronic components. Check wiring for shielding.
Poor low-frequency output
Improper polarity When two speakers in close proximity to each other are connected out-of-polarity, they can
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. Tronios cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
Hartelijk dank voor de aanschaf van onze SkyTec actieve luidspreker.
Lees deze gebruiksaanwijzing aandachtig door alvorens het apparaat in bedrijf te stellen.
NEEM VOOR EEN LANGDURIG EN VEILIG GEBRUIK DE VOLGENDE PUNTEN IN ACHT:
Action
Reseat all connectors
Substitute known good cables
Check solder joins
Inspect cable for damage
Inspect wire or connector for stray strand that may short
While it is possible for a faulty speaker to exhibit intermittent output, it's more likely
that an output cable/connector is the problem. Check the soldering on your
connectors.
partially cancel each other out, especially at low frequencies. Check your speaker
cables to be sure they are all identically wired and connected. Check the balanced line
signal cables to be sure they are all correctly wired.
ABS ACTIEVE PA LUIDSPREKERS
NL
check for noisy