Peaq PHP350BT-B Manual De Instrucciones página 23

in any way, such as the supply cord
or plug are damaged, liquid has been
spilled, objects have fallen into the
product, the enclosure is damaged,
the product has been exposed to rain
or moisture, does not operate normally,
or has been dropped.
Before connecting the product to a
socket outlet, make sure the voltage
indicated on the product corresponds
to your local mains.
Regularly check if the supply cord,
product or extension cable is defective.
If found defective, do not put the prod-
uct into operation. Immediately pull the
plug.
Place the supply cord and, if neces-
sary, an appropriate extension cable in
such away that pulling or tripping over
it is impossible. Do not allow the supply
cord to hang down within easy reach.
Do not jam, bend or pull the supply
cord over sharp edges.
Listen at reasonable volumes for rea-
sonable periods of time.
Using this headset with both ears cov-
ered while driving is not recommended
and may be illegal in some areas while
driving.
You should use caution or temporarily
discontinue use in potentially hazard-
ous situations.
Only use the provided adaptor.
The adaptor power plug is used as
the disconnect device; the disconnect
device shall remain readily operable.
To completely disconnect the power
input, disconnect the adaptor power
plug.
The product may not function prop-
erly or not react to the operation of any
control due to electrostatic discharge.
Switch off and disconnect the appli-
ance; reconnect after a few seconds.
Protect the supply cord from being
PHP350BT_B/W_IM_02.indb 23
walked on or pinched particularly at the
plug, convenience receptacles and the
point where it exits from the product.
Never pull the adaptor power plug by
the supply cord or with wet hands.
Disconnect the adaptor power plug in
case of faults during use, during light-
ening storms, before cleaning and
when not using the product for a longer
period of time.
Danger! Before cleaning, switch the
product off and disconnect the adaptor
power plug from the socket.
When the product has reached the end
of its service life, make it defective by
disconnecting the adaptor power plug
from the socket and cutting the cord
in two.
ENGLISH
23
9/28/12 6:00 PM