Installing The Control Element (Accessory); Setting Procedure - Dometic MS 880 Instrucciones De Montaje

MS880
9 Installing the control element
(accessory)
➤ Read the instructions enclosed with your control element carefully before
assembly.
10

Setting procedure

The procedure remaining after installation and connection depends on the type of
connection.
For CAN bus connections (connection to the CAN bus) you must perform the
following steps:
• To synchronise the system for CAN bus connection,
see chapter "Synchronising with a CAN-bus connection" on page 27
• To check the system connection, see chapter "Testing MagicSpeed (diagnosis
mode)" on page 32
• To test the system: see chapter "Testing functions" on page 38
For analogue connections (analogue speed signal) you must perform the
following steps:
• To synchronise the system for analogue connection,
see chapter "Synchronising with an analogue connection" on page 30
• Perform pedal test,
see chapter "Adjusting the accelerator pedal manually" on page 31
• To check the system connection, see chapter "Testing MagicSpeed (diagnosis
mode)" on page 32
• Start automatic mode,
see chapter "Starting automatic mode" on page 35
• Set the control sensitivity (if necessary),
see "Setting the control sensitivity (GAIN mode)" in the diagnostics manual on
our homepage
• To test the system: see chapter "Testing functions" on page 38
EN

Installing the control element (accessory)

25