Dometic eStore Instrucciones De Montaje página 26

Troubleshooting
Problem Cause
Status LED flashes eStore is configured to be con-
red. nected to multiple eStores and
BUS cables are not plugged in.
eStore is over discharged.
eStore is over charged
eStore ist defective.
eStore does not eStore is in storage mode.
respond to press-
eStore is over discharged.
ing of the main
switch command.
eStore is configured as slave and
not as master.
Configuration for connecting
multiple eStores is faulty.
eStore is defective.
26
Remedy
➤ Plug in eStore cables.
➤ Charge eStore.
➤ Disconnect chargers from
eStore.
➤ Check the charging voltage of
battery chargers.
➤ Contact an authorised work-
shop.
➤ Activate eStore.
➤ Charge eStore with a charging
current of < 10 A.
Note: Do not use intelligent
charging systems (with main
swtich open, the eStore termi-
nals have no voltage. Some
intelligent battery chargers do
not start if no voltage is present).
➤ Contact an authorised work-
shop.
➤ Use main switch command on
master eStore (eStore config-
ured #1)
➤ Check the configuration.
➤ Contact an authorised work-
shop.
eStore
EN