Bresser NATIONAL GEOGRAPHIC 90-48500 Instrucciones De Uso página 20

RISK of property damage!
Before charging, be sure to read about the correct
operating voltage in the operating manual of your end
device. No guarantee is provided for damages due to an
incorrect voltage selection.
Make sure that the lamp and radio are turned off. Move
the power switch to ON position.
Connect the 3.5 mm DC plug (Fig. 5, 9a) into the DC
connection socket (Fig. 5, 7).
Connect the USB-A connector (X) of your digital mobile
device into the USB A connection socket (Fig. 5, 9b) of
the adapter cable (Fig. 5, 9).
Fold out the hand crank (Fig. 4, 4) and turn it at a rate
of about 2.5 to 3 rotations per second. With the energy
thus generated, the connected mobile device's battery is
charged.
i
Note: The charging process with the hand crank
can take some time until the battery voltage for use of the
mobile device is sufficiently high, depending on the battery.
4. Use of the radio
Move the power switch to ON position. Press and hold the
„RADIO" (Fig. 2, 3a) button for about 3 seconds to turn
on the FM radio.
To search for stations, press, during radio playback, the
buttons „SCAN+" (Fig. 2, 3c) or „SCAN-" (Fig. 2, 3d). The
automatic station search is started and interrupted when
a station is found with sufficient signal strength. To search
for another station, perform the channel search again as
previously described.
The station search is carried out with „SCAN +" upwards
(frequency range from 87.5 MHz to 108 MHz) or with
„SCAN-" backwards (108 MHz to 87.5 MHz).
To adjust the volume, press, while the radio is playing,
the „VOL +" (Figure 2, 3e) button to increase the volume,
or „VOL-" (Fig. 2, 3f), to decrease it. Hold the respective
button down until the desired volume is reached.
Press the button again for about 3 seconds to turn off your
radio.
- 20 -