ELICA Pandora Instrucciones De Montaje, Uso Y Mantenimiento página 12

If your appliance is supplied with the motor
already mounted, remove the screws and the
suctioning unit in order to fit the downdraft into
the hole made.
• Fit the hood into the hole made, by inserting it
from above , as shown in (Fig. 2).
In the case of internal motor version, it is ne-
cessary to fit the power pack by directing the air
outlet towards the desired position, either down-
wards or upwards (Fig. 5). The motor can be fit
on both the front and rear side of the downdraft.
Once fitting the motor , the air-outlet piping can
be fit.
In the case of external motor version , the po-
wer pack ( external motor) shall be positioned in
a suitable place and the air exhaust piping shall
be fit. Install the air outlet piping between the
external motor and the downdraft. Select the
air-out let among the 5 possible options (Fig.6)
and fit the pipe fitting supplied.
After completing installation and connecting
the appliance to the power supply, lift up the
downdraft by pushing on the front piece seat,
as shown in fig. 7.
Then fit the charcoal filters, if the product is in
the filtering version, ( charcoal filters are not
supplied with the appliance and are purchasa-
ble in a specific kit) , the grease filters (see fig.
8), and finally the front glass as shown in fig. 9;
make sure to fit the glass properly , as shown
in fig. 10.
• Place the metal box containing the electronic
components in an easily reachable area for
possible technical assistance operations, by
connecting the electric connectors of the box to
the hood (fig. 11).
How the hood works
It is necessary to open the extractable unit in or-
der to ensure the appliance normal operation,
by following these steps.
Push the glass downwards, as shown in fig. 12;
the glass will be released and will open .
Following the extractable unit opening, it will be
possible to operate the suction motor by using
the push-button panel, as follows.
To close the extractable unit, push on the front
glass until the extractable unit is completely clo-
sed.
T1.
Timer ON/OFF key: press it to set the automatic
switching off:
Speed 1: 20 minutes
Speed 2: 15 minutes
Speed 3: 10 minutes
High Speed : 5 minutes
T2. Key to decrease the aspiration speed (power).
OFF 1: press it multiple times, in order in order to re-
duce the aspiration speed until the hood is turned off.
OFF 2: hold it down for a prolonged period of time,
at any speed.
T3. ON /aspiration speed (power) increase (1-2-3-High
speed) key.
The High speed lasts about 5 minutes: after that
speed 2 is automatically set.
11