Disposal; Troubleshooting - Honeywell D06F Instrucciones De Montaje

10. Disposal

The local regulations on proper waste recovery or
disposal must be observed!
10.1.D06F
• Housing made from dezincification-resistant brass
• Connections made from brass
• Valve insert made from high-grade plastic
• Fine filter made from stainless steel
• Spring bonnet with adjuster knob and setting scale made
from high-grade plastic
• Filter bowl made from clear plastic or brass
• Setpoint spring made from spring steel
• Diaphragm made from NBR, fabric-reinforced
• Seals made from NBR and EPDM
10.2.D06F-LF
• Housing made from lead-free brass
• Connections made from lead-free brass
• Valve insert made from high-grade plastic
• Fine filter made from stainless steel
• Spring bonnet with adjuster knob and setting scale made
from high-grade plastic
• Filter bowl made from clear plastic
• Setpoint spring made from spring steel
• Diaphragm made from NBR, fabric-reinforced
• Seals made from NBR and EPDM
10.3.D06FH
• Housing made from dezincification-resistant brass
• Connections made from brass
• Valve insert made from high-grade plastic
• Fine filter made from stainless steel
• Spring bonnet with adjuster knob made from high-grade
plastic

11. Troubleshooting

Malfunction
Banging noises
Water comes out at spring bonnet
No water pressure or not enough
The set outlet pressure does not
remain constant
MU1H-1002GE23 R0217
GB
• Filter bowl made from brass
• Setpoint spring made from spring steel
• Diaphragm made from NBR, fabric-reinforced
• Seals made from NBR and EPDM
10.4.D06FN
• Housing made from dezincification-resistant brass
• Spacer ring made from brass
• Connections made from brass
• Valve insert made from high-grade plastic
• Fine filter made from stainless steel
• Spring bonnet with adjuster knob made from high-grade
• Filter bowl made from brass
• Setpoint spring made from spring steel
• Diaphragm made from NBR, fabric-reinforced
• Seals made from NBR and EPDM
10.5.D06FI
• Housing made from stainless steel
• Connections made from stainless steel
• Valve insert made from high-grade plastic
• Fine filter made from stainless steel
• Spring bonnet with adjuster knob and setting scale made
• Filter bowl made from transparent plastic or stainless steel
• Setpoint spring made from spring steel
• Diaphragm made from NBR, fabric-reinforced
• Seals made from NBR and EPDM
Cause
Pressure reducing valve is oversized
Diaphragm of valve insert is defective
Shut-off valve upstream or downstream of
the pressure reducing valve is not fully
opened
The pressure reducing valve is not set to
the desired outlet pressure
Pressure reducing valve filter insert
contaminated
Pressure reducing valve not installed in
direction of flow
Pressure reducing valve filter insert
contaminated or worn
The nozzle or sealing disc of the valve
insert is contaminated or damaged
Pressure increase on outlet pressure side
(e.g. due to water heating device)
14
plastic
from high-grade plastic
Elimination
Call technical customer support
Replace valve insert
Open shut-off valves completely
Set the outlet pressure
Replace filter insert
Install the pressure reducing valve in the
direction of flow (observe the arrow direction
on housing)
Replace filter insert
Replace valve insert
Check the functionality of the check valve,
safety group etc.
Honeywell GmbH