Connecting The Power Supply Cord - Yamaha RX-397 Manual De Instrucciones

Connecting the power supply cord

Plug the power supply cord into the AC wall outlet after
all other connections are complete.
REMOTE jacks
VOLTAGE SELECTOR
REMOTE
IN OUT
VOLTAGE
SELECTOR
SPEAKERS
CLASS 2 WIRING
A
B
(General model)
■ REMOTE jacks
Some YAMAHA models are able to connect directly to the
REMOTE jack on the rear panel of this unit. If you own these
products, you may not need to use an infrared emitter. Up to six
YAMAHA components can be connected as shown below.
REMOTE
IN
Infrared signal
receiver
AC power supply cord
AC OUTLETS
SWITCHED
IMPEDANCE SELECTOR
SET BEFORE POWER ON
A OR B: 4ΩMIN. /SPEAKER
A + B: 8ΩMIN. /SPEAKER
A OR B: 8ΩMIN. /SPEAKER
A + B:16ΩMIN. /SPEAKER
AC OUTLET(S)
REMOTE
OUT IN
This unit
component
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost if
the power cord is disconnected from the AC wall outlet
for more than one week.
■ AC OUTLET(S) (SWITCHED)
Australia model ......................................................1 outlet
Other models ....................................................... 2 outlets
Use these outlets to connect the power supply cords from
your other components to this unit. The AC OUTLET(S)
supplies power to any connected components whenever
the power of this unit is turned on. For information on the
maximum power (total power consumption of
components), see "SPECIFICATIONS" on page 33.
■ VOLTAGE SELECTOR
(Asia and General models only)
VOLTAGE SELECTOR on the rear panel of this unit must
be set for your local main voltage BEFORE plugging the
power supply cord into the AC wall outlet.
Voltages are as follows:
Asia model ......................... AC 220/230–240 V, 50/60 Hz
General model ...... AC 110/120/220/230–240 V, 50/60 Hz
REMOTE
IN
OUT
YAMAHA
component
CONNECTIONS
REMOTE
OUT
YAMAHA
13