4.2 Enable Sync To External - PRESONUS SL-Dante-MIX Option Card Guía De Instalación Y Conexiones

4.2 Enable Sync To External

For StudioLive AI rackmount mixers, this can be changed from the
Input settings area. To assign an input on the RM mixer to a FireWire
source select the input source or open the Channel Settings view in
UC Surface and then change the source from Network to FireWire.
4.2 Enable Sync To External
Your StudioLive AI mixer is always the master clock. Because of this,
the SL-Dante-MIX card must be set to 'Enable Sync To External' so
it will use the external word clock from its host equipment.
Note: While the Dante network protocol supports devices of different
samples rates existing on the same network, only devices set to the same
sample rate can route audio to one another. The sample rate for your
StudioLive AI mixer must be set manually from the System menu. If you
are having trouble routing audio to and from your mixer, verify its sample rate
matches that of the devices you are trying to route audio to and from.
12
To do this, click on
the Clock Status tab
in the Dante
Controller
application and
check the Enable
Sync to External box
next to your mixer.