Carrying System; Switching On | Self-Check | Send Mode - Black Diamond GUIDE BT Manual De Instrucciones

4.2 CARRYING SYSTEM

BLACK DIAMOND recommends using the included carrying system
(3A) or an approved apparel pocket. In order to protect the
beacon's display, carry the beacon with its display facing inwards
(3B). The transmit control LED (1G) is visible in the pouch´s window
(3C).
The included hand loop is intended to be used for training sessions.
DANGER Risk of device loss
Always carry the device in the included carrying system or an approved apparel pocket!
Always leave the device cord-secured!

4.3 SWITCHING ON | SELF-CHECK | SEND MODE

Switching on: Move the slider lock (1C) to the left and the slider (1B) upwards into the position SEARCH. Then
release the slider lock (1C) and move the slider (1B) downwards, until it locks in the position SEND.
The display shows firmware version, battery capacity, self-check progress (4A), self-check result (4B), group check
countdown (4C) and finally the send display with the active transmitting antenna (4D).
The device is now in send mode, the transmit control LED (1G) is blinking.
NOTICE A minimum distance of 5 m from other devices and all electronic, magnetic and metallic sources
of interference should be kept during the self-check.
If the self-check is successful, "OK" is indicated on the display (4B). In the event of a device warning, an alert signal
sounds and the display indicates "E" in combination with a number (4E). For error codes, see chapter 6.1.
Manual BLACK DIAMOND GUIDE BT/RECON BT | Firmware v1.0 | 08/2018
(2A) Direction indication
(2B) Distance indication
(2C) Transmit symbol
(2D) Battery capacity/type
(2E) MARK (marking possible)
(2F) Active transmitting antenna
(2G) Number of burials (1-3)
(2H) Number of burials (4 or
more)
(2J) Transmitter marked
(2K) Bluetooth active
(2L) Inclinometer mode*
(2M) TX600 mode*
(2N) SCAN mode*
(2P) Analog mode*
(2Q) Meter symbol for SCAN /analog
mode*
* GUIDE BT only
9 / 23