Descargar Imprimir esta página

Trotec BL 30 Manual De Instrucciones página 19

Registrador de datos climáticos
Ocultar thumbs Ver también para BL 30:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 60
• You can set the measurement sampling rate for the
data logger with the field „Samprate setup" . Enter the
desired number in the left-hand box and the unit of
time in the right-hand box.
• You can set the time intervals at which the LEDs flash by
clicking the three time intervals (10s/20s/30s=seconds)
listed in the „LED Flash Cycle Setup" field . (If you click
„No Light", the LEDs do not flash when the values ex
ceed/fall below the user-defined limit values . This
mode preserves the batteries and ensures a longer
life span .
• Click on „Manual" or „Automatic" to specify whether
the data logger automatically enters recording mode
when you close the setup window („Automatic") or
only at a later time („Manual") by manually pressing
one of the two buttons .
• You can configure the upper (HIGH) and lower (LOW)
limit values for the temperature and the humidity with
the „Alarm Setup" field . In this field you can also set the
temperature units (°C/°F) and deactivate the LEDs .
• By clicking „Circulating Record" or „No Circulating",
m If the new settings are saved with „Setup"
operating instructions - climate data logger Bl30
you can decide whether the stored data should be
overwritten (Circulating Record) when the memory
is full or whether the data logger should not store any
further data in this case (No Circulating) and the re-
cording should stop . Click on the SETUP button to save
the settings . Click on the „Standard/DEFAULT" button in
order to restore the data logger's factory settings . Click on
the „Cancel" button in order to abort the setup .
after the execution of a setup, all previously
saved measured values are automatically de
leted! In order to prevent such a loss of data,
click on the „Cancel" button during the setup
to end the setup procedure prematurely. This
way the stored data can still be transferred to
another medium (e.g. PC) beforehand. On ac-
count of the duration or intensity (e.g. border-
line climatic conditions) of an application, the
battery life may not be sufficient for the in
B - 7

Publicidad

loading

Este manual también es adecuado para:

Bl30