Connecting Wires To Terminals - Kenwood KDC-135 Manual De Instrucciones

Connecting Wires to Terminals

Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control
terminal when using the optional power
amplifier, or to the antenna control
terminal in the vehicle.
Connect to the terminal that is grounded
when either the telephone rings or
during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
⁄
Do not let the wire come out from
the tab.
To front right speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
Purple
Car fuse box
–
Rear left output (White)/
Rear right output (Red)/
Sub Woofer left output (White) (KDC-135 only)/
Sub Woofer right output (Red) (KDC-135 only)
FM/AM antenna input
Power control/Motor antenna control wire
(Blue/White)
P.CONT
TEL mute wire (Brown)
MUTE
Not Used (Blue)
ANT.
CONT
ACC
Ground wire (Black) - (To car chassis)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
15
|
English