Kenwood KDC-X491 Manual De Instrucciones página 34

Troubleshooting Guide
HD Radio source
?
No sound can be heard, or the volume is low.
✔ The preset broadcast station is not transmitting in
the mode that was set with <Receive mode Setting>
(page 24).
☞ Please set <Receive mode Setting> to "AUTO".
✔ In digital AM broadcasting, receive mode switches
between stereo and monaural too often.
☞ Receiving condition is bad or unstable. Stereo is
chosen when receiving condition is good, and
it switches to monaural when the condition
becomes bad.
✔ HD Radio tuner is connected to KCA-S220A or other
units.
☞ Connect the HD Radio tuner directly to this unit.
USB device source
?
The USB device is not detected.
✔ The USB connector is disconnected.
☞ Connect the connector of the USB device
properly.
?
The USB device does not play its audio files.
✔ The USB connector is disconnected.
☞ Connect the connector of the USB device
properly.
34 |
English
The messages shown below display your
systems condition.
EJECT: • No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
• No CD in the unit.
NO DISC: No disc has been loaded in the disc
magazine.
TOC ERR: • No disc has been loaded in the disc
magazine.
• The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
READ ERR: • The number of files or folders which are
stored in the connected USB device is above
the limitation.
• The file system of the connected USB device
is broken.
➪ Copy the files and folders for the USB
device again referring to http://www.
kenwood.com/usb/. If the error message is
still displayed, initialize the USB device or
use other USB devices.
E-05: The disc is unreadable.
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD, although it
has a title.
NO PANEL: The faceplate of the slave unit being
connected to this unit has been removed.
E-77: The unit is malfunctioning for some reason.
➪ Press the reset button on the unit. If the
"E-77" code does not disappear, consult
your nearest service center.
E-99: Something is wrong with the disc magazine.
Or the unit is malfunctioning for some reason.
➪ Check the disc magazine. And then press
the reset button on the unit. If the "E-99"
code does not disappear, consult your
nearest service center.
LOAD: Discs are being exchanged in the Disc
changer.
READING: The unit is reading the data on the disc.
HOLD: The protective circuit in the unit activates
when the temperature inside the automatic
disc changer exceeds 60°C (140°F), stopping
all operation.
➪ Cool down the unit by opening the
windows or turning on the air conditioner.
As the temperature falls below 60°C
(140°F), the disc will start playing again.