Practical Applications - Metabo HPT C 12LCH Instrucciones De Manejo

English

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 20).
Line
1. Switch operation
Hole
Trigger
Switch
Fig. 21
WARNING:
2. Using the Vise Assembly (Standard accessory)
Screw Holder
6mm Wing
Bolt (B)
Fence
Vise Shaft
6mm Wing Bolt (A)
Fig. 22
WARNING:
CAUTION:
16
Warning Sign
Pull the trigger to turn on the switch, release it to shut it off.
After releasing the trigger, make sure the trigger has gone all the
way back and the switch is turned off.
This will ensure that the power tool cannot be turned on accidentally or by someone
(especially a child) who is not qualified to use the power tool.
To prevent unauthorized operation of this tool, insert a padlock through the hole in
the switch trigger.
(1) The vise assembly can be mounted on either the left fence
Knob
{Fence (B)} or the right fence {Fence (A)} by loosening the 6mm
wing bolt (A).
Vise Plate
(2) The screw holder can be raised or lowered according to the
height of the workpiece by loosening the 6mm wing bolt (B).
After the adjustment, firmly tighten the 6mm wing bolt (B) and
fix the screw holder.
(3) Turn the upper knob and securely fix the workpiece in position
(Fig. 22).
Workpiece
Always firmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
Always confirm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the 6
mm wing bolt (B) and move the vise assembly to a position where it will not contact
the saw blade.
Warning Sign
Fig. 20
Line