Punch-Through; Copy A Command From Another Key - NAD S170i Manual Del Usuario

ENTER
Press the enter key when in the Library Mode will make the currently selected table become active and
will exit the Library Mode.
NOTE
Making a table active will deactivate any currently learned commands and active Punch-through
functions. Deactivated learned commands can be restored again (without having to relearn them) as
described in the Copy Mode section of this manual.
DISPLAY
The Display key can be used to determine the reference number for the table you have currently selected.
After pressing the Display key, the table number will be displayed by flashing the Tape, VCR, and Macro
keys, corresponding to the first, second, and third digits of the command table. For example: if the table
number is 103, then the TAPE key would flash once, followed by the Macro key flashing three times.

PUNCH-THROUGH

The HTR 2's "punch-through" function allows you to retain a function key from one Device Select "page"
on another, so that, for example, the AMP [SURR MODE] function might still control the S170i when the
DVD Device Selector page is active
NOTE
The HTR 2's [VOL] and [MUTE] keys are pre-programmed as "punched-through" for all Device Select
pages (except TV): [VOL] and [MUTE] will operate the NAD's master-volume regardless of the currently
selected device. The [SURR.] [CENTER,] and [SUB] Channel Volume controls similarly are pre-
programmed as punched-through for all devices.
To set a punch through, after entering the Learning Mode, and pressing the desired key to be punched-
through, simply press the device key twice of the device to punch through to. The status LED will turn
green; press the Device Selector key again to exit Learning Mode.
Example: Punch-through to the DVD "page" from the AMP [SURR MODE] key:
• On the HTR 2, simultaneously press-and-hold [DVD] and
green.
• Press [SURR MODE]; the Learn LED turns amber.
• Press [AMP] twice; the Learn LED turns green.
• Press [DVD] again to exit the learning mode.

COPY A COMMAND FROM ANOTHER KEY

You may copy a command from any HTR 2 key to any other. To copy a Control key function, after entering
the Learning Mode, and pressing the desired key to be copied to, simply press the device key from which
you wish to copy, having first pressed its Device Selector key if it resides under another Device key. The
status LED will turn green; press the Device Selector key again to exit Learning Mode.
Example: Copy the Pause command from the CD key to the AMP
• On the HTR 2, simultaneously press-and-hold [AMP] and
green.
• Press (pause); the Learn LED turns amber.
• Press [CD]; press [ || ] (pause); the Learn LED turns green.
• Press [AMP] again to exit the learning mode.
NOTE
• The copy and punch-through functions are similar. However, if you copy a command and then
subsequently delete, or over-write the original (source-key) command, the copied-to key's command
remains unchanged. If you punch-through to a command and then delete or over-write the original
key, the punched-through functions also change accordingly.
• If the source function, and destination function are the same, the HTR-2 will restore a previously deleted
learned command if one exists. So, if you accidentally deleted a learned command or loaded a library
table over learned commands, this is a quick way to restore them without having to relearn them.
USING THE HTR 2 REMOTE CONTROL
(record); the Learn LED turns steady
key:
(record); the Learn LED turns steady
33