HSGM B 50 Instrucciones De Uso página 12

7.2. Please charge the battery-operated soldering gun
In order to charge the battery-operated soldering gun
charging unit
6
sure that the battery charge indicator light
to be verified whether there is contact between the mains plug
discharged battery-operated soldering gun
approximately 14 hours. It is not possible to overcharge the battery.
7.3. The operating voltage of the charging unit
7.4. The lockout device
turning the locking mechanism to position "I" by means of the attached screw
driver (see Fig.1).
11
7.5 The battery-operated soldering gun
(see power indicator light
period of 9 seconds, which can be controlled most easily by bringing the soldering
tip in contact with the solder
5
be performed in a timely manner for capacity reasons of the NiMH batteries, and, on
the other hand, to prevent a generally possible overheating of the electronic compo-
nents. Place the soldering tip
of solder between the soldering tip
13
transfer. After it has been heated up, add more solder
the solder distributed itself well, the soldering tip
13
gun can be turned off. A shiny, flawless surface of the soldering joint should remain.
1
7.6 In order to prevent a fire hazard after completion of the soldering operations, the
lockout device
secured against inadvertent operation.
7.7 The soldering tip
refinished (for instance, by using a file, etc.)!
7.8 The soldering tip
still warm.
7.9 We recommend using a standard flux-cored soft solder, which is sold through
relevant specialist retailers.
where it will be reloaded automatically. When charging, please make
of the battery-operated soldering gun
10
Fig. 1
Switch is released
Fig. 2
Switch is locked
). The soldering temperature is reached after a warming-up
7
. The soldering process itself should, on the one hand,
13
on the soldering joint and simultaneously put a little bit
5
must be turned back to position "0" (see Fig. 2). The device is now
10
is protected against wear and oxidation and must, in no case, be
5
shall be cleaned by using a viscose sponge
5
before putting it into operation.
1
, it needs to be placed on the
1
lights up. If it does not light up, it needs
7
is completely recharged overnight within
1
is indicated on the type plate
6
is turned on by pressing down the gear lever
1
and the work piece to enhance a better heat
5
13
can be removed and the soldering
5
10
and the outlet. A fully
8
.
9
can be released by
1
on the soldering joint. Once
or cloth while it is
14
12