JB Systems Light LED QUADRO PANEL Manual De Instrucciones página 8

ENGLISH
DMX-CONFIGURATION OF LED QUADRO PANEL SWITCHED IN 1CH MODE:
There's one additional 1CH DMX-channel mode for applications where you need
a quick and simple standalone setup but with the possibility to switch the panel(s)
on/off and select the preprogrammed shows.
OPERATE THE UNIT BY RF8SET
When used in standalone or master/slave mode we strongly advise you to use the RF-8SET "Wireless easy
controller".
 RF-8SET wireless remote: the wireless remote has two parts:
 RF-8T: small RF-transmitter that can control up to 5 effects.
 RF-8R: small RF-receiver that should be connected to the DIN 5pin input of the
LED QUADRO PANEL. See the installation manual of the receiver for more
information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
 The MODE LED on the RF-8R is off: with the FUNCTION button you can select different
strobe modes, like "sound strobe".
 The MODE LED on the RF-8R is on: press the FUNCTION button to change the colors
(music mode is temporarily switched off)
 The MODE LED on the RF-8R is blinking slowly: with the FUNCTION button you can
select different shows.
 The MODE LED on the RF-8R is blinking fast: with the FUNCTION button you can select different show
speeds.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When the plastic front panel is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
JB SYSTEMS 11/65
®
OPERATION MANUAL
LED QUADRO PANEL
ENGLISH
SPECIFICATIONS
Mains Input: AC 100 - 240V, 50/60Hz
Max Power consumption: 32 Watt
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
Leds: 144pcs SMD 5060 RGB-leds
DMX-channels: 1, 4 and 16 channels + special 2MSL
Size: 500 x 500 x 101 mm (see also drawing)
Weight: 6kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS 12/65
®
OPERATION MANUAL
LED QUADRO PANEL