JB Systems PARTY BAR Manual De Instrucciones página 6

ENGLISH
DESCRIPTION:
1. RGB PROJECTOR
2. RGB DERBY PROJECTOR
3. LASER UNIT
4. WHITE FLASH LED
5. HANGING BRACKETS: Fix one bracket at each extremity of the bar by using the 2 knobs. You can now
fix a mounting hook (or fast clamp) in each bracket hole.
6. 35mm POLE STAND ADAPTER
7. INTERNAL MICROPHONE: is used to synchronize the sound controlled shows to the beat of the music.
8. IR-RECEIVER: When you use the wireless remote control that is delivered with the Party Bar you have
to point the infra-red remote controller to this infra-red receiver. There are 2 IR-receivers on the bar, one
on the front and one on the rear of the bar
9. MAINS LINK OUTPUT: you can use a special IEC power cable to connect this output with the mains
input of the next bar or projector for easier linking (Max. total load on one power line = 10A)
10. MAINS INPUT: IEC socket with integrated fuse holder and switch, connect the supplied mains cable
here.
11. DMX OUTPUT: 3pin female XLR-connector used to connect the Party Bar with the next unit in the DMX
chain.
12. DMX INPUT: 3pin male XLR-connector used to connect universal DMX-cables. This input receives
instructions from a DMX-controller (in DMX mode) or from the previous bar (in Master/Slave mode).
13. INTERLOCK input: used to connect the optional emergency stop switch (see picture). When you push
this switch the laser beam will disappear immediately.
JB SYSTEMS® 4/87
USER MANUAL
PARTY BAR