Honeywell Turck Si35-K10-Y1 Manual De Instrucciones página 6

Idiomas disponibles

Honeywell

1 Intended use

This device fulfills the directive 2014/34/EC and is suited for use in

explosion hazardous areas according to EN 60079-0:2012 + A11 and EN

60079-11:2012.

Further it is suited for use in safety-related systems, including SIL2 as per

IEC 61508. In order to ensure correct operation to the intended purpose it is

required to observe the national regulations and directives.

2 Hazardous areas

II 2 G and II 1 D (Group II, Category 2 G, electrical equipment for gaseous

atmospheres and category 1 D, electrical equipment for dust atmospheres).

3 Marking

 II 2 G and Ex ia IIC T6 Gb acc. to EN60079-0 and -26 and

 II 1 D Ex ia IIIC T95 °C Da IP67 acc. to EN60079-0

4 Local admissible ambient temperature

-25...+70 °C

5 Installation/Commissioning

These devices may only be installed, connected and operated by trained and

qualified staff. Qualified staff must have knowledge of protection classes,

directives and regulations concerning electrical equipment designed for use

in explosion hazardous areas.

Please verify that the classification and the marking on the device comply

with the actual application conditions.

This device is only suited for connection to approved Exi circuits according

to EN 60079-0 and EN 60079-11. Please observe the maximum admissible

electrical values.

After connection to other circuits the sensor may no longer be used in Exi

installations. When interconnected to (associated) electrical equipment,

it is required to perform the "Proof of intrinsic safety" (EN60079-14).

Attention! When used in safety systems, all content of the security manual

must be observed.

73024998a