To Use; Care And Maintenance - Beurer FC 45 Manual De Instrucciones

6. To Use

1. Moisten the Brush Head with water. Never use the Brush Head while it is dry as this can irritate the skin.
2. Apply cleanser or product of your choice on your face (not included).
3. The device has both a fast and a slow speed setting. Press down on the On/Off Button for 2 seconds to
activate low speed. Press down on the On/Off Button again to switch to high speed.
4. Place the brush against your face and use a gentle, circular motion to remove residue, dirt and dead skin
cells. To avoid irritation, do not press the brush too firmly to the skin. Treat each section of your face for a
maximum of 20 seconds.
5. To shut the device off, press and hold down on the On/Off button for 2 seconds until the motor stops.
6. Cleanse your face thoroughly with water to remove any residue from your skin.
7. Pat the skin dry with a soft, dry towel and apply a moisturizing cream of your choice.
8. Recommended usage time is one minute per session. The device will shut off automatically after one minute.

7. Care and Maintenance

• Before cleaning, pull the brush head off the handle. Clean the brush thoroughly with water after each use.
• Protect the product from knocks, dust, chemicals, extreme temperatures and nearby sources of heat (ovens,
heaters).
• Clean the Handle with a soft, slightly moistened cloth. You can also moisten the cloth with mild soapy water.
Do not use any abrasive cleaning products.
7