Peg-Perego Duette sw Instrucciones De Uso página 10

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: READ THE
INSTRUCTIONS CAREFULLY
BEFORE USE AND KEEP THEM FOR
FUTURE REFERENCE. THE CHILD
MAY BE HURT IF YOU DO NOT
FOLLOW THESE INSTRUCTIONS.
_ THIS PRODUCT IS DESIGNED FOR
CHILDREN WHOSE MAXIMUM
WEIGHT IS 45 POUNDS (20 KG) AND
WHOSE MAXIMUM HEIGHT IS 43
INCHES (110 CM). THIS SHOPPER
BASKET IS DESIGNED TO CARRY A
MAXIMUM WEIGHT OF 11 POUNDS
(5 KG). ANY POACH OR POCKET
PROVIDED WITH THIS UNIT IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ FAILURE TO FOLLOW
MANUFACTURER'S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE
UNIT TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT. ALWAYS
USE COMPLETE 5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD
UNATTENDED.
_ ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN
MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF ALL
MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
_ DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
_ ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.
_ CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS
BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED
FLAME.
_ CHILD MAY SLIP INTO LEG OPENINGS
AND STRANGLE, NEVER USE IN
RECLINE CARRIAGE POSITION
UNLESS FOOTREST ENCLOSURE IS
FULLY INSTALLED/IMPLEMENTED
(SEE MANUAL INSTRUCTIONS FOR
CORRECT USE).
NOTICE
THIS ARTICLE MEETS OR EXCEEDS
ALL REQUIREMENTS COVERED IN
ASTM F833 STANDARD AND LATEST
REVISIONS.
INSTRUCTIONS
1 FITTING THE WHEELS: remove the four
protective caps, (two round and two square)
from the folded chassis, as in the figure.
2 WARNING: distinguish the front wheels (Fig. A)
from the rear wheels (Fig. B), as in the figure.
3 Fit the front wheels, which are shown in
Figure A, while the base is closed. It is
necessary to push the locking lever down
(fig. B) and at the same time push the hub
onto the pin (fig. C). Check that the wheels
are properly attached by pulling them in
opposite directions.
4 To fit the rear wheels, repeat the action
carried out for the front wheels (sequence B
and C). The rear wheels can be identified by
the black teeth, as shown in figure A. Check
that the wheels are properly attached by
pulling them in opposite directions.
5 BRAKE: to activate the brake on the chassis,
push down with your foot on the brake bar
- 10 -