1. Select a Location
When choosing a location for your HRL-100-60W, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet when using the supplied power cord .
• Ensure operating temperatures are not below 32
Fahrenheit or above 158° Fahrenheit (below 0° Celsius
or above 70° Celsius) .
• If using photocell, place controller where photocell can
be exposed to sunlight .
• Ensure at least 9 inches of space to the left of the
landscape lighting controller box for the door to swing
open after installation .
• Locate the controller where there is easy access to
light wire . If mounted in an outdoor location, shut the
compartment door to keep the controller safe from
weather damage . To lock: insert the key and turn
clockwise to the locked position .
Interiores
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
If desire to use photocell, place controller where
photocell can be exposed to sunlight .
Allow 9 inch clearance for the swing door
Exteriores
Note: Landscape lighting controllers are weather-resistant
to UL-50 and ETL
Listings, but should not be placed in areas
®
where continuous water could cause damage.
6
STATION
Landscape Lighting
TEST ALL
START TIME
1
2
RESET
AUTO
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2. Mount the Controller
• Use the mounting template (included) to mark the
mounting screw location on the wall . See Figure 1.
• Install a No . 8 screw (included) into wall in the upper
template location . Leave the screw head protruding 1/8
inch (3mm) from wall . Use expanding anchors (included)
in plaster or masonry, if necessary, for a secure hold .
• Slip the HRL-100-60W over protruding screw (using
keyhole slot in back) . See Figure 2.
• Drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See Figure 2.
4.17"
(106mm)
Figure 1: Use Mounting Template (included)
Keyhole
Pre-formed
mounting holes
Figure 2: Hang timer on screw using keyhole
MOUNTING TEMPLATE
GABARIT D`INSTALLATION
GUIA DE COLGAR
1/8"
No. 8 Screw
Wall