Saw Blade Selection; Saw Blade Change; Riving Knife/Splitter; Operation - Mafell MAF02100/a Manual De Instrucciones

The internal diameter of hose connector 3 (Fig. 3) is
28 mm (1 7/64 in.).

4.5 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts along and across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 24 teeth
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 12 teeth
For cuts especially across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 40 teeth
For cuts in laminate:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 40 trapezoidal teeth
Order No. see special accessories.

4.6 Saw blade change

Danger
Unplug the rechargeable battery for
all service work.

Press the locking bolt 8 (Fig. 2).

Using the Allen-key 3 (brackets Fig. 1), unfasten
the flange screw 8 (Fig. 3) counter clockwise;
remove the screw as well as the front clamping
flange 7.

Now you can remove the saw blade after
opening the retractable saw guard 9.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

In doing so, keep the locking bolt depressed.

4.7 Riving knife/splitter

Danger
Unplug the rechargeable battery for
all service work.
The riving knife / splitter 6 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 8).

For adjustment, unfasten the screw 4 (Fig. 3)
with the Allen-key supplied with the saw 3 (Fig.
1).

Adjust the riving knife/splitter by shifting it in its
longitudinal slit. Afterwards retighten the screw.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: First press the switch-on lock 1
(Fig. 1) and then press the switch trigger 2.

Switching off: To switch off, release the switch
trigger.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 40 mm (1 15/16 in.).
Proceed as follows:

Unfasten the clamping lever 5 (Fig. 1).

Set the cutting depth with the plunge lever 6
(Fig. 2).

The cutting depth can be read off the scale 2
(Fig. 5) on the cover. Zone 1 on the plunge lever
with the red background serves as indicator for
this purpose.

Retighten the clamping lever.
Always set the cutting depth
approx. 2 to 5 mm (1/16 to 3/16 in.)
larger than the material thickness
to be cut.
-23-
to the chapter "Safety