Oven Racks - GE JBS03 Manual Del Usuario

Care and cleaning of the range.
Wire cover holder
Clean under the range.
26
Oven Heating Elements
Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated.
To clean the oven floor, gently lift the bake
element. Clean with warm soapy water.

Oven Racks

Clean the oven racks with an abrasive cleanser
or scouring pad. After cleaning, rinse the racks
with clean water and dry with a clean cloth.
NOTE: Take the racks out of the oven before
you begin the self-clean cycle or they may
discolor.
Oven Light Replacement
CAUTION:
Before replacing your
oven light bulb, turn the oven light off and
disconnect the electrical power to the range at
the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Hold a hand under the cover so it doesn't
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
Do not remove any screws to remove the
cover.
Replace bulb with a 40-watt household
appliance bulb.
Storage Drawer Removal
To remove the storage drawer:
Pull the drawer out all the way.
Tilt up the front and remove it.
On some models, the bake element is not
exposed and is under the oven floor. If
spillovers, residue or ash accumulate on the
oven floor, wipe up before self-cleaning.
To make the racks slide more easily, apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.
(on some models)
To replace the cover:
Place it into groove of the light receptacle.
Pull wire forward to the center of the cover
until it snaps into place.
Connect electrical power to the range.
For models JBS27DI and JBS27SI: Replace
oven lamp with 240 volts lamp only.
(on some models)
To replace the storage drawer:
Insert glides at the back of the drawer
beyond the stop on range glides.
Lift the drawer if necessary to insert easily.
Let the front of the drawer down, then
push in to close.