Urrea 6205 Manual De Usuario Y Garantía página 23

1. Connect supplied USB cable from computer to
wrench.
2. Computer will display "AutoPlay" window
showing CTECH as a disk drive with option of us-
ing Windows Explorer to view files.
3. Click "Open Folder" selection to display CTECH
Character Separated Value (.csv) file.
NOTE: If "AutoPlay" does not start automatically,
use Explorer to display CTECH drive contents.
4. Open file using Microsoft Excel by double click-
ing on file name (Example: "1213590002.CSV")
or "drag and drop" file to computer.
5. Data on wrench can be cleared by deleting file
on the CTECH drive.
MAIN MENU
Main menu displays wrench operational infor-
mation.
1. From target torque or angle screen, press and
hold ENTER button for 3 seconds.
2. Use UP/DOWN buttons to highlight menu se-
lection then press ENTER button.
Menu Selections:
• EXIT: Exits Main menu and returns to target
screen.
• LANGUAGE: Displays language selection menu.
• SET HEAD LENGTH: Displays wrench head
length entry screen.
• SHOW DATA: Displays stored torque and angle
data.
• CLEAR DATA: Clears stored torque and angle
data.
• CYCLE COUNT: Displays torque/angle cycle
count screen.
• SETTINGS: Displays advanced settings menu
(see Advanced Settings Section).
• CONFIGURE: Displays advanced configuration
menu (see Advanced Configuration Section).
3. To select the language menu, press the ENTER
button while LANGUAGE is highlighted then
highlight the desired language and press the EN-
TER button.
4. To exit Main menu and return to target torque
or angle screen, press ENTER button while EXIT
menu selection is highlighted.
NOTE: English defaults to decimal point.
SETTING HEAD LENGTH
NOTE: If wrench has an adapter or extension is
added, length of adapter and/or extension be-
ing used can be entered to correct for a different
length without requiring re-calibration.
E N G L I S H •
1. To enter a head length, from target torque or
angle screen, press and hold ENTER button for
3 seconds. 2. With SET HEAD LENGTH menu se-
lection highlighted, momentarily press ENTER
button.
3. Set Head Length screen is displayed next. De-
fault head length is length of head at calibration
(zero for fixed head wrench). Use UP/DOWN but-
tons to increment/decrement head length. Press-
ing and holding UP/DOWN buttons will progres-
sively increment/decrement value faster.
4. Default units of length is in inches. Press UNITS
button to change to millimeters.
5. Pressing ENTER button after length is set re-
turns to main menu. If length is changed from
default, "OFFSET IN USE" message will be dis-
played on target screen.
NOTE: For a fixed length flex head, head
length entered is offset length measured from
center of drive to center of fastener.
Offset
USE OF NEGATIVE OFFSETS
NOTE: Enter a negative value for offset when
used in reverse direction.
Offset
U se r's m a n ua l
23