Decalcification; Storage; Troubleshooting - Profi Cook PC-HGA 1196 Manual De Instrucciones

CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Clean the appliance regularly.
• Clean the outside with a damp cloth. A mild detergent
can be used for heavy dirt. Do not use aggressive clean-
ing agents or sprays.
• Thoroughly wash the inside of the tank and rinse with
fresh water.
• Only use a soft cloth and never use any kind of abrasive
cleaners, which might cause scratches.
• Do not use steel wool for cleaning. Small pieces might
come off the steel wool, get stuck in the tap, and cause
damage to the sealing surface.
• Use a soft, dry cloth to dry and polish the surface after
cleaning.
• Make sure the appliance was cleaned properly before
storing it in a dry place.
Tap
When used daily, the whole tapping mechanism must be
cleaned once a week, when used more rarely, it does not
have to be cleaned that often.
1. Unscrew the tap's upper part for cleaning, detach the
silicon cone, and clean all parts in warm water with a
mild detergent. Rinse with clean water.
2. Clean the inside of the tap and the connection to the tank
with a small bottle brush.
CAUTION:
Never push the brush into the assembled tap because
it would damage the silicon
3. Wipe the interior of the tap's bottom part dry.
4. Firmly push the silicone cone onto the tap´s upper part
until it clicks into place.
5. Screw the tap's upper part back on.
Problem
It is not possible to switch the
appliance on.
PC-HGA1196_IM_new
cone.

Troubleshooting

Possible Cause
The appliance has no power supply.
The appliance is faulty.
After the appliance has been used without
or with too little liquid, the appliance has not
cooled down sufficiently.
Water Level Indicator
1. Unscrew the knurled nut from the water level indicator.
2. Pull the transparent tube out of the sleeve. If needed,
you may also unscrew the sleeve.
NOTE:
Make sure that the two silicone seals are not getting
lost.
3. Clean the individual parts in warm water to which mild
detergent has been added. Rinse with clean water.
4. Screw the sleeve back onto the drain tap. The lower
thread must no longer be visible.
5. Insert the tube together with a silicone seal at the bottom
into the sleeve.
6. Before screwing the knurled nut back on insert the sec-
ond silicone seal into the upper part of the tube.

Decalcification

• The frequency of the decalcifying operation depends
on the hardness of the water and on how often the
appliance is used.
• Calcareous water causes a layer of lime to settle in the
tank, especially at the bottom of the tank, which can
influence the heating capacity of the appliance.
• Please do not use vinegar but a commercially available
decalcification agent on the basis of citric acid. Only use
the quantities stated in the instructions.
NOTE:
After decalcifying the appliance boil fresh water in it sev-
eral times in order to remove any residues. Do not use
this water for consumption.

Storage

• Clean the appliance as described and allow it to dry.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.
• Always store the appliance out of the reach of children in
a dry, well ventilated place.
Remedy
Check the socket with another appli-
ance.
Plug in the mains plug correctly.
Check the main circuit breaker.
Contact our service centre or a
specialist.
Fill with more liquid and let the appli-
ance cool down a bit.
39
15.10.19