Door Blocking System; Application With Hinged Door Icms; Application With Sliding Door Icms - FRIGOGLASS ICOOL-40 Manual De Usario


Master Alarm indication lit (stable).
Compressor On

Compressor ON indicator lit during "ON" cycles (stable). This indicator is OΝ whenever the
compressor is On.
For instructions of the functionality of Evocool FFA1 Controller and its related optional features, please
visit the following website link: http://www.frigoglass.com/manuals/

5. Door blocking system

In using the door blocking system, please follow the steps below
5.1

Application with hinged door ICMs

To block the Door at 90 degree:
Step 1: Open the door to an angle slightly greater than 90 degrees
Step 2: Remove the door blocker from bracket below the door (as shown in the picture)
Step 3: Rotate the door blocker towards the cabin and insert it in bracket located at front grid (as
shown in the picture)
To unblock the Door:
Step 1: Open the door slightly greater than 90 degrees and remove the door blocker manually from
bracket located at front grid
Step 2: Rotate the door blocker towards door and snap fit in bracket below the door (Initial position)
5.2

Application with sliding door ICMs

Step 1: Open the left door (same procedure also for right door)
Step 2: Lift up and rotate the door blocker towards the cabin (as shown in the picture)
Step 3: Place door blocker vertical to door guides (as shown in the picture). Door blocker will be
blocked at door guides walls and prevent the door to close.
Step 4: Release the door blocker from the stopping point and rotate to the initial position
*
optional feature
Automatic removal of door blocker from bracket located at front grid is
for accidental purpose only.
*
ENG
17