Quick CRYSTAL Serie Manual Del Usuario página 11

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
:
WARNING
the Quick
ses. Quick ® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of
the equipment.
Always deactivate the windlass when not in use.
Check that there are no swimmers nearby before dropping anchor.
use a three-strand rope and make an effective splice, seeking expert advice if necessary.
recommend installing at least two anchor windlass controls in case one is accidentally damaged.
the use of the Quick
Secure the chain with a further device before starting the navigation.
must be installed in a point protected from accidental water contact.
THE PACKAGE CONTAINS:
user's manual - warranty card.
TOOLS REQUIRED FOR INSTALLATION:
Ø 105 mm (4"1/8) hollow mill; hexagonal wrenches: 10 mm and 13 mm.
"QUICK ® "ACCESSORIES RECOMMENDED:
(mod. HRC1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC1102M and
CHC1202M) - Radio control (mod. 1302,1352; 02, 302).
INSTALLATION REQUIREMENTS:
the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appro-
priately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures
listed in the table. In cases of other thicknesses it is necessary to consult a Quick
deck to the passage of cables, rope and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE:
Remove excess material from the chain passage, refine and flatten with a specialized product (marine paint, gel coat or two
pack epoxy) to assure free passage for both rope and chain. Place the upper part in position and connect it to the bottom part.
Secure the windlass by using the studs and the screws supplied. Connect the supply cables from the windlass to the reversing
solenoid unit.
:
WARNING
before wiring up, be sure the electrical cables are not live.
CRYSTAL 600/1000/1100 - REV002E
®
windlasses are designed to weigh the anchor.
The windlass is not designed for the loads that might occur in extreme weather conditions (storms).
® hydraulic-magnetic switch as the motor safety switch.
windlass - reversing solenoid unit - base gasket - handle - bolts and screws (for assembly) -
drill and drill bits: Ø 6 mm (1/4") and Ø 9 mm (23/64") - Ø 57 mm (2" 1/4) and
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that
when the ideal position has been established, drill four holes using the drilling template provided.
PAINT
" DEALER.
®
anchoring RL control board (mod. 800) - Waterproof hand helds R/C
max
5 mm
(3/16")
INSTALLATION
Do not use the equipment for other purpo-
For mixed rope-chain installation always
For improved safety we
The solenoid unit or reversing solenoid unit
® retailer. There must be no obstacles under
40 cm
(16")
45°
GB
We recommend
11