Quick CRYSTAL Serie Manual Del Usuario página 15

POS. DESCRIPTION
13 Pressure lever
14 Screw
15 Rope/chain stripper "C"
16 Chain guide cover
17 Base
18 Plug
19 Gasket / jig Crystal
20 Sensor
21 Bearing
22 Key
23 Long shaft
24 Short shaft
25 Bearing
26 Screw
27 Movable gear
28 Ring
29 Planet gear
30 Fixed gear
31 Screw
32 Circlip
33 Sun gear
34 Key
35 Plug
36 Fifth wheel
37 Plug
38 Casing seal
39 Gearbox casing
40A Electric motor 500W 12V
40B Electric motor 800W 12V
40C Electric motor 800W 24V
41 Flange gasket
42 Poles gasket
43 Watertight
44 Bottom protec cover
electric motor
45 Screw
46 Studs
47 Washer
48 Spring washer
49 Nut
CRYSTAL 600/1000/1100 - REV002E
CODE
PDLVTD08ASCN
MBV0512MXCE0
Quick
MSN10ASX0000
ant to marine environments.
SGMSGG08ASC1
In any case, any salt deposits on the outside must be
SGMSC08ASC00
removed periodically to avoid corrosion and damage to the
MSR08XASC000
equipment.
PGBSG08C0000
The parts where salt may have built up should be washed
KNREEDCL0000
thoroughly with fresh water.
MBJ160060000
MBH0606020X0
Once a year, the drum and the gypsy are to be taken apart
MSAS08125R00
as follows:
MSAS08086R00
DRUM VERSION
MBJ618150000
Use the handle (1) to loosen the bush (2); pull off the drum
MBSC05016A00
(3) and the top clutch cone (5); loosen the fixing screws (14)
MSLCRM541000
of the rope/chain stripper (15) and remove it. Pull off the
MBA8066225B0
gypsy (6).
ZSNGGS000000
MSLCRF571000
NO-DRUM VERSION
MBSC06016A00
Use the handle (1) to remove the gypsy cover (4); remove
MBAE0808Y000
the top clutch cone (5); loosen the fixing screws (14) of the
MSLRTS151000
chain stripper (15) and remove it and pull off the gypsy (6).
MBH020220F00
MBSC04007A00
Clean all the parts removed to avoid corrosion, and grease
MBRRL2848010
the shaft thread (23 or 24) and the gypsy (6) where the
MBSC06012A00
clutch cones rest (5 and 7).
MMCRMT08C000
SGMSGCR08C00
Remove any oxide deposits from the terminals of the elec-
EMF0512C0000
tric motor and the reversing solenoid unit; grease them.
EMF0812C0000
EMF0824C0000
PGGPMFN04000
PGGPMPM04000
PCCCPM040000
PCCPPMFN0400
MBV03916AXCC
MBP080608X00
MBR08X000000
MBR08XDE0000
MBD08MXEN000
MAINTENANCE
WARNING: make sure the electrical power to the
motor is switched off when working manually on the
windlass. Carefully remove the chain from the gypsy.
®
windlasses are manufactured with materials resist-
GB
15