Initial Starting / Run-In Behaviour - Solo 879-12 Manual De Instrucciones

Ocultar thumbs Ver también para 879-12:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

x Loosen the screw (q) of the clamp (r) until the clamp can be moved upwards at the blank spar of the top
handle (s).
x Push the clamp upwards so far that the water supply line can never be in contact with the cut-off wheel.
x Check placement of the water supply line when the wheel guard is rotated all the way to the front and
correct if required.
Install handle for wheel guard adjustment and cut-off wheel again
x Install the handle for wheel guard adjustment (3) again to the wheel guard with the respective
attachment screws.
x Install the cut-off wheel: Î Chap. 5.1, page 16
5.9

Initial starting / run-in behaviour

After production, the power tool is subjected to an inspection and test process that ensures that the motor
is then run in perfectly.
Therefore, no special measures are required for initial start-up.
Move water supply line attachment upwards
The water supply line must be placed so
that contact between water supply line and
cut-off wheel in operation is excluded in all
positions of the wheel guard.
x Place the water supply line so that it runs on the
outside of the wheel guard and not between the
wheel guard and the assembly flange.
x Push the attachment screws (a) of the water
supply line into the adapter pieces (b).
x Place the adapter pieces on the right and left
sides of the wheel guard above the associated
threaded holes (p) and screw in the water supply
line attachment screws.
Preparing for use
ENGLISH 23

Publicidad

Tabla de contenido
loading

Productos relacionados para Solo 879-12

Este manual también es adecuado para:

879-14

Tabla de contenido