Nikon AF-S NIKKOR 24-120mm f/4G ED VR Manual De Instrucciones página 17

Idiomas disponibles

Notes on using vibration reduction

• If this lens is used with cameras that do not have

the vibration reduction function (pg. 14), set the

vibration reduction ON/OFF switch to OFF. With

the Pronea 600i/6i camera, in particular, battery

power may become quickly depleted if this switch

is left ON.

• After pressing the shutter-release button halfway,

wait until the image in the viewfinder stabilizes

before pressing the shutter-release button the

rest of the way down.

• Due to the characteristics of the vibration

reduction mechanism, the image in the

viewfinder may be blurred after the shutter is

released. This is not a malfunction.

• When taking panning shots, be sure to set the

vibration reduction mode switch to NORMAL. If

the camera is panned in a wide arc,

compensation for camera shake in the panning

direction is not performed. For example, only the

effects of vertical camera shake is reduced with

horizontal panning.

• Do not turn the camera off or remove the lens

from the camera while vibration reduction is

operating. Failure to observe this note could

result in the lens sounding and feeling as if an

internal component is loose or broken when it is

shaken. This is not a malfunction. Turn the

camera on again to correct this.

• With cameras featuring a built-in flash, vibration

reduction does not function while the built-in

flash is charging.

• When the camera is mounted on a tripod, set the

vibration reduction ON/OFF switch to OFF.

However, it is recommended that the switch be

set to ON when using the camera on an

unsecured tripod head or with monopod.

• With autofocus cameras featuring an AF-ON

button, vibration reduction does not function

when the AF-ON button is pressed.

Tabla de Contenido