Introduction - NEC NP01SW Serie Manual De Instalación

Introduction

Thank you very much for purchasing the NEC Interface selector NP01SW series (NP01SW1/
NP01SW2).
This product is equipped with various input terminals and the HDBaseT output terminal.
By utilizing this product, it makes simple to connect several devices with our projector or display
in a classroom or a meeting room. The receiver box is supplied with the interface selector for
NP01SW2.
• This product equips various input terminals (HDMI (x 3), Mic, LAN, USB-A, USB-B, etc) and
the remote control sensor.
• This product equips the HDBaseT output terminal. This able to receive/transmit HDBaseT sig-
nal from/to the projector or display which equips the HDBaseT input terminal connecting by a
commercially available LAN cable.
* The receiver box is included with NP01SW2, it can be connected with the projector or dis-
play not equipped the HDBaseT input terminal.
* HDBaseT is a connection standard for home appliances that is established by the HDBaseT
Alliance.
* Use a commercially available LAN cable satisfied the below specifications for connecting to
the HDBaseT port.
Conditions
Not connecting to the receiver
box
Connecting to the receiver box
(Note) It may not fulfil its performance depending on a cable.
• The HDMI input terminal and HDBaseT port on this product support HDCP.
• The HDMI3 input terminal supports MHL. It can be connected with the MHL supported smart
phone or tablet by using a commercially available MHL cable.
• This product can be connected with the Interactive Whiteboard kit for the NEC projectors.
• For the projectors or displays equipped the slot, it can be input HDBaseT signal by loading
the option board, SB-07BC, into the slot and connect with this product by a commercially
available LAN cable. (The receiver box is not required.)
• For checking supported projectors and displays, please visit our web site.
NOTE
• Transmittable signals by this product are determined. Please check and set up the output sig-
nal from video devices to supported signal in advance. Please refer to Specifications on page
ENG-24 and ENG-25.
Disposing of your used product
EU-wide legislation as implemented in each Member State requires that used electrical
and electronic products carrying the mark (left) must be disposed of separately from
normal household waste. When you dispose of such products, please follow the guid-
ance of your local authority and/or ask the shop where you purchased the product.
After collecting the used products, they are reused and recycled in a proper way. This
effort will help us reduce the wastes as well as the negative impact such as mercury
contained in parts to the human health and the environment at the minimum level.
The mark on the electrical and electronic products only applies to the current European
Union Member States.
Cable length
M a x . 100m ( M a x 70m f o r
transmitting 4K signal)
Max. 30m
ENG-2
Cable specifications
CAT5e or over STP cable
Recommended thickness AWG23
CAT6A or over STP cable
Recommended thickness AWG23