Adjusting The Cutting Depth; Angle Adjustment - Zipper Maschinen ZI-KGS250 Manual De Instrucciones

Never look directly into the la-
ser. Do not turn the laser to-
wards reflecting surfaces, ani-
mals or people.
Only
suitable saw blades.
Change damaged saw blades
immediately.
Blunt saw blades increase the
danger of kickback!
Do not overload the machine.
3 STARTING UP
3.1 Included in delivery ZI-
KGS250 (Fig. B)
Unpack the ZIPPER mitre saw and check
the machine for any transport damage
and for completeness of delivery.
Accessories:
a. tools
b. Carbon brush 2x
c. Operation manual
3.2 Assembly
· Insert the batteries for the laser (35)
· Mount the two work piece supports
(20)
· Insert the work piece binder (19)
· Mount the dust collector bag (24)
· Fix the saw on the ground (work bench
/ machine stand)
A T T E N T I O N
FORBIDDEN: Adjustments when
the machine s connected with
the power supply!
Injuries and material damages
by unintentional starting!
So always
machine from the power supply
before adjusting works.
Make sure that all the screws,
levers, etc are fastened well and
that
removed
before operation.
use for the ZI-KGS250
disconnect
loose tools have
from the machine
3.3
The maximum cutting depth results from
the deepness of the cutting line. The saw
blade must not touch the machine bed
anytime!
The
cutting depth is 5mm
under the upper edge of
the work piece support.
Adjust
limitation 35 analogous.
After that you have to
lower the saw aggregate
to the lowest position
and turn the saw blade with the hands to
test the free run.
For groove cuts (the material is not cut
completely) you must swing out
deepness limitation so that the deepness
limitation screw rests on it when lowering
the saw aggregate. Adjust this screw (the
longer one).
3.4
Cutting angles are factory setted. For
precision mitre cuts you have to adjust
the angle adjustment on the fence and the
mitre angle. After long operation you have
to control this regularly.
3.4.1
· Set the saw aggregate to the 0° posi-
· Lower the saw aggregate to the low-
· Fix the aggregate in this position by
· Pull the saw aggregate forwards so
· Fix the aggregate in this position.
· Measure the angle between saw blade
the
· If the angle differs from 90° you have
· These are fixed with 2 socket head
been
Adjusting the cutting
depth
recommended
the deepness
Angle control

Angle adjustment

tion.
est position.
latching the lock pin (from the right
side in front of the machine).
that it rests on the fences.
side and the fence à 90° Should
to adjust the fences on both sides.
screws on every fence. Loosen them,
adjust the fence and fasten them
again.
EN
the