Publicidad
Idiomas disponibles
Idiomas disponibles
Mesh filters installation
(for models: 54800
and 54810).
It is recommended
to install side filters first and finish with center one(s).
Install as follows:
1) Insert upper end of filter into the hood (filter tab side).
2) Raise lower end toward
the inside of hood.
3) Position rear part of filter into channel and pull.
4) Using filter tabs, puii on the upper end of filter and slide it under the front inner retaining
piece.
i
HDOOOg
Replacement
filters are available.
|
Refer to page 12 for ordering
information.
1
Baffle filters installation (for models: 54820, 54830 and 54840 only).
_hb
CAUTION:
Remove protective plastic film covering filters before installlng them.
It is recommended
to install side filters first and finish with center one(s).
Install as follows:
Make sure the filters are positioned
as shown thus allowing
the grease to reach the channel
easily.
A verical
arrow with the word AIR can be found on filter border;
make sure to install the filter with the arrow
aiming
toward
the inside of the hood. See illustrations
below.
H
i
i
i
io
Publicidad
