Installation; Fitting/Exchanging The Lamp - Futurelight MH-420 Manual Del Usuario

Installation

Fitting/Exchanging the lamp

DANGER!
Install the lamp with the device switched off only.
Unplug from mains before!
Lamp Cover
Screws "W , X, Y , Z"
To insert the lamp (CDM-SA/T 150/942, G-12 socket) open the top cover of the head (see the drawings to
identify which cover is top) by loosening the 4 Phillips screws on the front and rear sides of the top cover.
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not
designed for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer's
notes!
Do not touch the glass-bulb bare-handed during the installation! Make sure that the lamp is installed tightly
into the lampholder system.
Adjust the optimal distance 1-1.5 mm from the lens by turning the screw "A" (see the drawings "Lamp
adjustment" below).
Reclose the top cover of the head and tighten the Phillips screws.
Before striking the lamp, reset the "LAti" counter and the "LASt" counter in the main menu of the Control
Board, by pressing the "Up" and "Down" buttons in one time and then confirming with the Enter-button.
Do not operate the fixture with opened housing-cover!
40