Product Description; Specifications - Shindaiwa 22T Manual Del Propietário

Product Description

1. Gearcase
. Outer Tube
3. Handle
4. Grip
5. Cutting Attachment
Shield
6. Cylinder Cover
7. Throttle Lever
8. Fuel Tank
9. Ignition Switch
1
Figure 4

Specifications

Engine Model .................... S0
Engine Type ...................... -cycle, vertical cylinder,
air cooled
Dry weight, T
(excluding guard and
cutting attachment) ........... 4.1 kg/9.0 lb
Dry weight, F
(excluding guard and
cutting attachment) ........... 4. kg/9.3 lb
Bore x Stroke ..................... 31 mm x 8 mm/1." x 1.10"
Displacement ..................... 1.1 cc/1.9 cu. in.
Maximum Power
Output ................................ 0.9 hp/0.7 kw @ 7500 rpm (min
Transmission Type ........... Automatic, centrifugal
clutch with bevel gear
Fuel/Oil Ratio .................... 50:1 with Shindaiwa Premium
-cycle Engine Oil
Fuel Tank Capacity ........... 400 ml/13.6 ounces
Carburetion ........................ Walbro WYL (w/primer)
Ignition System ................. Electronic
Specifications are subject to change without notice.
Inspect
The F and T come fully assembled
with the exception of the cutting
attachment shield and cutting attachment.
Before completing the assembly, carefully
inspect the unit and all components for any
damage and make sure all components are
there.
3
5
2
5
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit:
 Engine and shaft assembly
 Cutting attachment shield
 Cutting attachment
 Kit containing cutting attachment shield
6
22T
4
9
8
22F
7
6
9
4 8
7
3
Spark Plug .......................... Champion CJ-8.
Air Cleaner ......................... Semi-wet type
Starting Method ................ Recoil Starter
Stopping Method ............... Slide switch
Handle ................................ Loop type
EPA Emission
Compliance Period* .......... Category B
* The EPA emission compliance referred to on the emission compliance
label located on the engine, indicates the number of operating hours for
which the engine has been shown to meet Federal emission requirements.
)
-1
Category C = 50 hours (Moderate), B = 15 hours (Intermediate) and A =
300 hours (Extended).
Using the illustrations in this manual
as a guide, familiarize yourself with
your unit and its various components.
Understanding your unit helps ensure
top performance, long service life, and
safer operation.
WARNING!
Do not make unauthorized
modifications or alterations to either of
these units or their components.
For electromagnetic
compliance (EMC) use
NGK BMR6A
mounting bracket and hardware, this
owner/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a hex
wrench set, a spark plug/screwdriver
combination wrench, and a spanner.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal
operation.
5