Velleman MA620B Manual Del Usuario página 5

8. RED/WHITE WIRE – PARKING LIGHT POWER –
This wire is the "COM" point of parking light.
10. WHITE/BLACK WIRE – SIREN DRIVE OUTPUT –
This is the positive (+) output connection for the siren. Connect this wire to the (+) red
wire coming from the siren. And connect the black (-) wire of the siren to a good chassis
ground.
11. BLUE WIRE – LED INDICATOR –
This wire is the output wire for the connection of the alarm's LED status indicator. Connect
the blue wire to the black wire of the LED indicator. Connect the red wire of the LED
indicator to a constant + 12 volts.
B. BLACK THIN WIRE - RF ANTENNA :
The BLACK thin wire on the alarm is the receiver antenna wire. Antenna placement is very
important! Ensure that it is unwrapped and stretched out with the last 6" straight and keep it
away from large metal objects or chassis for best reception. After installation pass this
antenna wire along with other wires through rubber cap for water-proof.
After all wiring completed, follow the steps to program transmitter, selector and shock
sensitivity.
A. PROGRAMMING TRANSMITTER :
Programming the transmitter codes, when the alarm completely installed. (Maximum
programming capacity is 4 transmitter to a single alarm unit.) It is important to remember that
during programming, each step must execute within 10 seconds of the previous step. When 10
seconds time limit due, the system will automatically exit program mode. It will be indicated
by a long "chirp" from the siren.
ENTER PROGRAMMING TRANSMITTER MODE :
1. Turn the ignition switch off - on.
2. Then turn the valet switch on - off 3 times. There
will be a chirp for confirmation. It is on
programming transmitter mode.
3. Press your transmitter's button I until the alarm send
a confirmation chirp. It is programmed.
4. If you have additional transmitters you can follow
the step 3 to program additional transmitters.
Note : When first transmitter code is learned it will
erase all other prior codes and protect your alarm
against unknown codes being entered without your
knowledge.
EXIT PROGRAMMING TRANSMITTER CODE:
Turn the ignition switch off when you finish
programming.
MA620B
PROGRAMMING AND ADJUSTMENT
5
button 1
button 2
VELLEMAN