Parameters During Current Input - Query Test - akkuteam VAS 5903 Instrucciones De Uso

Starting current 3.
input test manually
(continued)
1.
Parameters
during current
input - query test
Current input test Important! before disconnecting the charging terminals from the battery, the displayed
finished - battery parameters must be entered on the battery test sheet in accordance with the Volkswa-
OK gen Group testing instructions for starter batteries.
1.
2.
Start test
If there is no confirmation of correct pole connection within 2.5 secs, the device
reverts to menu mode.
Press the info button to display the parameters in the following sequence:
- actual battery current
- actual battery voltage
- amount of charge (Ah) fed in so far
- energy (Wh) fed in so far
- time that has elapsed since the start of the test (hh:mm)
After a pre-defined test time, the current input test ends and the results are shown
on the display:
Bsp.: Batterie Ok
If the battery is classed as chargeable, the machine automatically switches to
standard charging mode. Press the Info button to view stored test parameters and
the actual charging parameters.
Test parameters are identified by the test symbol
E.g.: charging current
E.g.: set battery capacity
E.g.: device serial number
E.g.: validation code
- the top half of the display shows the
results of the current input test
(charging bars are shown when the
result is positive)
- the bottom half of the display shows
the relevant validation code
E.g.: battery voltage
E.g.: Battery's ability to
accept charge, expressed
in %
E.g.: firmware version
15