Measuring Blood Pressure; Positioning Cuff; Correct Posture; Select Memory - Beurer medical BM 70 Manual De Instrucciones

5. Measuring blood pressure

5.1 Positioning cuff

Fit the cuff round your bare left upper
arm. Blood circulation in the arm
should not be restricted by tight
clothing or other objects.
The cuff should be placed on the
upper arm so that the lower edge is 2
to 3 cm above the bend of the elbow
and above the artery. The tube should
be in line with the centre of the palm.
Now place the free end of the cuff
snugly, but not too tightly, around the
arm, and fix it with the Velcro fastener.
The cuff should be fitted tight enough
to allow just two fingers to fit beneath
the cuff.
Insert the cuff tubing into the socket
for the cuff attachment.
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference of 24
to 36 cm. A larger cuff for upper arm circumferences from 34 to
46 cm is available from retailers or the service address under
order no. 162.797.

5.2 Correct posture

• Rest for approx. 5 minutes before each measurement. Other-
wise there may be divergences.
• You can perform the measurement either sitting or lying down.
Always make sure that the cuff is on a level with your heart.
• To carry out a blood pressure measurement, make sure you
are sitting comfortably with your arms and back leaning on
something. Do not cross your legs. Place your feet flat on the
ground.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.

5.3 Select memory

You have two memories (60 memory spaces each) in order to
save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Select the required memory space by pressing the user selec-
tion button . Confirm your selection with the On/Off button
5.4 Measuring blood pressure
• Put on the cuff as described previously and assume the posi-
tion in which you want to carry out the measurement.
• Press the user selection button
and press the key 2x to start measurement in the chosen
memory zone. After checking the display with all digits light-
ing up, the monitor will automatically inflate. Following the
19
to select a memory zone,
.