Specific Functions - STERWINS 750 DW-3 Instrucciones De Montaje

Operate the product : illustration 4.1 to 4.5
It is recommended to use a rope attached to the handle to install the pump at the bottom of the water.
CAUTION ! Do not use the power cord nor the float switch to lift
the pump.
Make sure that the pump is installed upright and stable on the bottom of the water.
Then make sure that the float switch is raising in upper position. Pump needs at least 40 cm of water to
start automatically.
Plug in the electrical outlet.
Note : The pump will start automatically after plugging the
cable outlet.
• Operate the product only at reasonable hours – not early in the
morning or late at night when people might be disturbed.
• Do not modify the product in any way or use parts and
accessories that are not recommended by the manufacturer.
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service center.
Stop the pump
Once the water is drained, the floater moves to the low position and the pump stops by itself.
• You shall never block the floater manually
• To reduce the risk of injury, always stop the machine :
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect
immediately)
.

4.5 SPECIFIC FUNCTIONS

There is no specific function about this product.
179
13
FR
FR
ES
ES
PT
PT
IT
IT
EL
EL
PL
PL
RU
RU
KZ
KZ
UA
UA
RO
RO
EN
EN