Rimax RB205 Manual De Instrucciones página 36

If you have seen the opening screen, but nothing appears afterwards.
 Please check if your Camera unit is turned on. The green Power LED will light
up and indicate the system is on.
 Make sure the Camera unit and Monitor Unit are within the appropriate range of
each other. For trouble shooting purpose, you should remove all the obstacles
between the two devices. Try a shorter distance.
 Please remove the battery and unplug the A/C adapter. Wait for 10 minutes.
 Plug the A/C adapter back to the Monitor Unit and retry to power on the
Monitor Unit.
 If all above steps fail, you are advised to pair the Monitor Unit and Camera
Unit.
 Please following the steps mentioned in Pairing/New Added Camera Unit.
If you would like to return to the default settings, press and hold [
press on/off, and then press [
FCC Statement
WARNING: Modifications not authorized by the manufacturer may void user´s
authority to operate this device.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on , the user is
encouraged to try to correct the interference by one or more of following measures :
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

]. The setting will be restored.
36
], meanwhile