Guard With Cover Plate; Technical Data; Before Use; Fitting The Side Handle - Hilti DAG700-P Manual De Instrucciones

3.7 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3.8 Guard with cover plate

CAUTION
When grinding with straight grinding discs and cutting with cutting discs in metalworking applications,
use only the guard with cover plate. This is available as an optional accessory.

4. Technical data

Right of technical changes reserved.
Information about the power tool and its applications
Drive spindle thread (arbor size)
Spindle length
Protection class

5. Before use

WARNING
Never use the power tool without the guard.

5.1 Fitting the side handle

WARNING
The side handle must be fitted for all types of work.
The side handle may be screwed onto the left, right
or top side of the power tool.
5.2 Guard
CAUTION
The closed side of the guard must always face the
operator.
NOTE
The keyed locating lug on the guard ensures that only
a guard designed for use with the power tool can be
Printed: 07.07.2013 | Doc-Nr: PUB / 5069467 / 000 / 00
" 11
"
Protection class II (double insulated)
fitted. The keyed locating lug also prevents the guard
from coming into contact with the disc.
5.2.1 Fitting and removing the guard 2
1. Disconnect the supply cord plug from the power
outlet.
2. Fit the guard so that the locating lug engages in
the notch in the spindle collar and then rotate it
into the required working position.
3. Secure the guard by tightening the screw.
4. To remove the guard from the power tool, follow
the instructions for fitting the guard but carry out
the steps in the reverse order.
5.2.2 Adjusting the guard 3
1. Disconnect the supply cord plug from the power
outlet.
2. Slacken the screw.
3. Rotate the guard to the desired position.
4. Secure the guard by tightening the screw.
en
9