Working With The Machine; Guide Types; Service And Maintenance; Accessories - Festool MFK 700 EQ Manual De Instrucciones

8

Working with the machine

Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
– Hold the machine with two hands, one on the mo-
tor housing and one on the gear head or addition-
al handle [1-6] to ensure safe guidance.
– Adapt the feed rate to the cutter diameter and
material. Work with a constant feed rate
8.1

Guide types

Routing with ball bearing guide [6]
When routing with cutters with a ball bearing guide
the ball bearing brake must be inserted in the edge
router. The edge router is guided so that the ball
bearing guide of the cutter rolls between the brake
and edging.
Adapt height of the brake to the height of the
ball bearing guide - 2 stages [6A].
Routing with plane cutter [7]
The ball bearing brake is not used when routing
with plane cutters. Guide edge router so that the
stop of the router table is at the edging - also pos-
sible at diagonal edges.
9

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the

socket before performing maintenance work on
the machine!
All maintenance and repair work which requires

the motor housing to be opened must only be
carried out by an authorised service workshop.
The machine is equipped with special carbon
brushes. If they are worn out, the power is inter-
rupted automatically and the machine comes to a
standstill.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
Observe the following instructions:
To ensure constant air circulation, always keep

the cooling air openings in the housing clean
and free of blockages.
10

Accessories

The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11

Environment

Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
12

EU Declaration of Conformity

Edge router
MFK 700 EQ
Year of CE mark: 2007
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following directives, standards and normative
documents:
2006/42/EG, 2004/108/EG, 2011/65/EU, EN 60745-
1, EN 60745-2-17, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical
Documentation
2014-12-05
MFK 700 EQ
GB
Series No.
500299
13